Avery Dennison S 45 Uživatelský manuál stáhnout pdf (Strana 13)

09/07 Rev. 3.04-01 USER MANUAL Maintenance

TTX x50/67x – Wildcats/Wildcats plus – S 45/65/95/105 – TDI/STDI/XXtreme

Photoelectric switches

Cleaning the punch photoelectric switch

1. Switch off the device.

2. Unplug from the mains.

3. Remove the material and foil.

4. Loosen the print head holder and rotate it upwards. The punch

photoelectric switch can now be easily accessed from the front (see [8]

P Refer to section Cleaning the

print head on page 5.

[8] Print head rotated upwards.

The punch photoelectric switch

(1) is easily accessible.

5. Clean the punch

photoelectric switch (1) with compressed air

(canned compressed air can be ordered as an accessory).

If there is heavy contamination, you must also clean it with cleaning spirit

and a dustless cloth.

6. After cleaning, return the print head holder to the old position and tighten

the wing screws (TTX x67) or the thumb screw (TTX x50) again.

TTX 67x:

Press the wing screws onto the beveled edge of the square axle to ensure

that the print head holder is in the exact position on the axle.

TTX x50:

The thumb screw engages in a groove on the axle, ensuring that the print

head is in the exact position on the axle.

For both printer types, you must also pay attention to the position of the

print head in relation to the edge of the label. Default setting: up against the

internal black plastic bushing.

7. Before switching the device on, make sure that the print head cable is

properly connected.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Žádné komentáře

Avery Dennison S 45 Uživatelský manuál Strana 13